Makita GA7012C Manual De Instrucciones página 5

ENGLISH
(Original instructions)
1 Shaft lock
2 Switch trigger
3 Lock lever
4 Indication lamp
5 Side grip
6 Wheel guard
7 Screw
8 Bearing box
9 Nut
10 Lever
11 Lock nut
SPECIFICATIONS
Model
Depressed center wheel diameter................................................180 mm
Max. wheel thickness ...................................................................6.5 mm
Spindle thread ..............................................................................M14
No load speed (n ) / Rated speed (n)...........................................8,400 min
0
Overall length ...............................................................................453 mm
Net weight.....................................................................................4.3 kg
Safety class .................................................................................. /II
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
Explanation of general view
12 Depressed center grinding
wheel/Multi-disc
13 Inner flange
14 Super flange
15 Lock nut wrench
16 Abrasive disc
17 Rubber pad
18 Wire cup brush/Wire bevel
brush
19 Abrasive cut-off wheel/diamond
wheel
GRINDER SAFETY WARNINGS
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
ENE048-1 1.
ENF002-2
2.
3.
GEA010-1
4.
5.
6.
20 Wheel guard for abrasive cut-off
wheel/diamond wheel
21 Outer flange 78
22 Inner flange 78
23 Exhaust vent
24 Inhalation vent
25 Commutator
26 Insulating tip
27 Carbon brush
28 Screwdriver
29 Brush holder cap
GA7012C
–1
This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool. Read
all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
Operations such as polishing are not recom-
mended to be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
Do not use accessories which are not specifi-
cally designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controlled.
Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of the
flange. Accessories that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
GA9012C
230 mm
6.5 mm
M14
–1
6,000 min
453 mm
4.5 kg
/II
GEB033-7
5