Moon Phases - Hama EWS-3200 Instrucciones De Uso

6.5. Maximum and minimum temperature and
humidity values
The base station automatically stores the maximum and
minimum indoor/outdoor temperature and humidity values.
• Brie y press the + button (36) repeatedly to switch the
display between the current temperature and humidity,
maximum temperature and humidity (MAX) and minimum
temperature and humidity (MIN).
• Press and hold the + button in the MAX/MIN view for
more than three seconds to delete the saved maximum and
minimum values.
6.6. Outdoor temperature alarm
• Repeatedly press the CHANNEL button (35) to select the
measuring station channel (28) for which you would like
to set an alarm.
• Press and hold the – button (33) for approx. 3 seconds
until the outside temperature display ON/ OFF begins
to ash.
• Press the + button (32) or the – button (33) to select ON/
OFF´ and con rm your selection by pressing the MODE´
button (31).
Select ON/ OFF to activate/deactivate the outside
temperature alarm.
The corresponding symbol (27) is displayed when the alarm
is activated.
• The symbol for the upper limit value
limit value (28) ashes.
• Press the + button (32) or the – button (33) to set the
displayed limit value and con rm your selection by pressing
the MODE button (31).
• Then repeat this procedure for the lower limit value
The alarm is triggered correspondingly if the outdoor
temperature reaches one of these limit values.
The symbol (27) and the outdoor temperature start to ash
and an alarm signal sounds.
Press any button to stop the alarm
Note – Outdoor temperature alarm
• You can de ne a lower and an upper limit value and
activate an alarm for each channel and/or connected
measuring station.
• Note that the lower limit value must be at least 1°C/1°F
below the upper limit value.

6.7. Moon phases

The base station indicates the current moon phase (16) with
the following symbols:
Display (16)
6
is displayed and the
Moon phase
New moon
Waxing crescent (1/6)
6.8. Comfort range
The base station displays the following comfort ranges based
on the ration between the current room temperature and
room humidity:
Display (23)
.
6.9. Backlight
Press the SNOOZE/LIGHT sensor (37) to activate the
backlight.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents. Make sure that
water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
Waxing crescent (1/3)
Waxing half moon
Waxing moon (2/3)
Waxing moon (5/6)
Full moon
Waning moon (5/6)
Waning moon (2/3)
Waning half moon
Waning crescent (1/3)
Waning moon (1/6)
Comfort range
– Pleasant –
Ideal temperature and humidity
– Moist –
Humidity too high
– Dry –
Ambient air too dry