Moon Phases - Hama EWS-3200 Instrucciones De Uso

Ocultar thumbs Ver también para EWS-3200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
• If you do not make an entry for the 20 seconds, the current
atmospheric pressure (4) is displayed again automatically.
• The bar graph (5) shows the history of the atmospheric
pressure within the last 12 hours.
• As soon as the room temperature falls below +4°C, the
symbol for risk of frost (27) is displayed.
6.5. Maximum and minimum temperature and
humidity values
The base station automatically stores the maximum and
minimum indoor/outdoor temperature and humidity values.
• Repeatedly press the + button (36) to switch the
display between the current temperature and humidity,
maximum temperature and humidity (MAX) and minimum
temperature and humidity (MIN).
6.6. Outdoor temperature alarm
• Repeatedly press the CHANNEL button (35) to select the
measuring station channel (28) for which you would like
to set an alarm.
• Press and hold the – button (33) for approx. 3 seconds
until the outside temperature display ON/ OFF begins
to flash.
• Press the + button (32) or the – button (33) to select ON/
OFF´ and confirm your selection by pressing the MODE´
button (31).
Select ON/ OFF to activate/deactivate the outside
temperature alarm.
The corresponding symbol (27) is displayed when the alarm
is activated.
• The symbol for the upper limit value
limit value (28) flashes.
• Press the + button (32) or the – button (33) to set the
displayed limit value and confirm your selection by pressing
the MODE button (31).
• Then repeat this procedure for the lower limit value
• The alarm is triggered correspondingly if the outdoor
temperature reaches one of these limit values.
The symbol (27) and the outdoor temperature start to flash
and an alarm signal sounds.
Press any button to stop the alarm.
Note – Outdoor temperature alarm
• You can define a lower and an upper limit value and
activate an alarm for each channel and/or connected
measuring station.
• Note that the lower limit value must be at least 1°C/1°F
below the upper limit value.

6.7. Moon phases

The base station indicates the current moon phase (16) with
the following symbols:
is displayed and the
.
Display (16)
Moon phase
New moon
Waxing crescent (1/6)
Waxing crescent (1/3)
Waxing half moon
Waxing moon (2/3)
Waxing moon (5/6)
Full moon
Waning moon (5/6)
Waning moon (2/3)
Waning half moon
Waning crescent (1/3)
Waning moon (1/6)
7

Publicidad

Tabla de contenido
loading

Tabla de contenido