Bluetooth ® Pairing - Hama Pure Instrucciones De Uso

5. Operation
Switching the headset off/on
• Press and hold the MFB button (2) for about 3
seconds until a voice says 'Power ON' and the
LED (4) flashes blue three times.
• To switch the device off, press and hold the MFB
button (2) for about 5 seconds until a voice says
'Power OFF' and the LED (4) flashes red three
times and goes out.
Note
The functions described in this section are
only available for Bluetooth
devices.
5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• The headset and the terminal device should not
be any further than 1 metre away from each
other. The smaller the distance, the better.
• Switch the headset on using the MFB button (2).
• Press and hold the MFB button (2) for about 3
seconds until a voice says 'PAIRING' and the
LED (4) emits flashes of alternating red and blue
light. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth
device and wait until Hama BTH PURE appears in
the list of Bluetooth
• Select Hama BTH PURE and wait until the headset
is listed as connected in the Bluetooth
on your terminal device.
-capable terminal
®
-capable
®
is
®
-capable
®
settings on your terminal
®
devices found.
®
settings
®
Note – Bluetooth
Some terminal devices require a password in
order to connect to another Bluetooth
• If your terminal device requests a password
for connection with the headset, enter 0000.
Note
• If the connection was successful, the LED (4)
flashes blue.
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled
and the LEDs go out. In this case, repeat the
steps listed previously under 5.1 Bluetooth
pairing.
5.2. Automatic Bluetooth
successful pairing)
Note
• Make sure that your Bluetooth
®
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• Switch the headset on using the MFB button (2).
The blue LED begins to flash and the headset
automatically connects with the last terminal
device used.
®
Note
• If the connection was successful, the LED (4)
flashes blue.
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled and
the LEDs go out. In this case, repeat the steps
listed previously under 5.1.
• It may be necessary to make settings on
your terminal device to enable automatic
connection with the paired headset.
password
®
device.
®
®
connection (after
®
-capable
®
is
®
-capable
®
®
3