Error Code Guide - Honeywell TP30 Manual Del Propietário

ERROR CODE GUIDE

CODE POSSIBLE CAUSE
P1 Water tank pull out
EH Humidity sensor failure
Temperature sensor
E1 / E2
failure
E3 Gas leakage
Electrical products should be properly disposed of. Please recycle where facilities exist.
This only appears for model
TP70P with Built-in Drain Pump.
Position the water tank correctly into the unit. Unit
will not operate until the water tank is secure in place.
Please contact the service center.
Please contact the service center.
If E3 appears, Please the check the ambient
temperature range whether below 89.6°F (32°C).
If the ambient temperature over 89.6°F (32°C) place the
unit below 86°F (30°C) for 2 hours before running the
Dehumidifier again.
If the E3 appears again in 2 hours, please contact the
service center.
Check with your local authority or retailer for recycling.
EN 21
NOTE