Device Connection - Sveon SNT1020 Manual De Usuario

Note: If your network doesn´t appear or you can not
see any available network, disconnect and connect
again the SNT1020 device.
14. Select the network you want to connect and enter
the network password. Click on "Ok".
15. When the connection is done, the status of con-
nection will appear as "Connected".
16. To verify if the connection is properly done and if the Modem or router has provided the connection information, go to
"Network" menu and check the connection.
Note: IP data IP 192.168.1.100 may change depending on the setup and the Modem/Router model.

8. Device connection

1. Connect the device or the USB stand to an available USB port of your computer. It will be recognized and installed by
the Windows installation wizard automatically.
2. Access to the device through "Start" menu > "Ralink Wireless Utility" or through this icon
located in the Windows bar.
- Windows XP operating system
- Windows Vista operating system
- W7 operating system
SNT1020 User Manual
Index
1. Welcome
2. Features
3. System requirements
4. Technical specifications
5. Content
6. Hardware
7. Driver installation on PC
7.1 Windows XP/Vista/W7
7.2 Ubuntu (Kernel 2.6.31)
7.3 Mac (Snow Leopard 10.6.2)
8. Device connectiontivo
8.1 RaUI setup
9. Network connection
9.1 Network connection using WZC
9.2 Network connection using RaUI utility
9.3 Network connection in AP-Mode (Ad Hoc)
9.4 Network connection with WPS
10. RaUI software control panel
10.1 Network
10.2 Profile
10.3 Advance
10.4 Statistics
10.5 WMM
10.6 WPS
10.7 SSO
10.8 CCX
10.9 Radio On/Off
10.10 About
11. MAC address specifications
English 30