Operation; Backpack Battery (530Ibx) - Husqvarna 436LiB Manual Del Usuario

To adjust the harness
1. Put the hip pad straps through the fastenings in the
harness for the backpack battery.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks. Use a
brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery will not charge if the battery
temperature is more than 50 °C/122 °F. If the
519 - 002 - 30.05.2018
2. Adjust the harness to optimize the work position.

Operation

temperature is more than 50 °C/122 °F, the battery
charger will cool down the battery.

Backpack battery (530iBX)

The backpack battery capacity is shown with digits on
the product and the LED lamps on the backpack battery.
See the backpack battery operator's manual for
information about how to charge and do maintenance on
the backpack battery.
To charge the battery
Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
9