Assembly; Operation - Husqvarna 320iB Mark II Manual Del Usuario

SAVE THESE
INSTRUCTIONS
To assemble the tube on the product
1. Put the blower nozzle over the tubular end of the
product.
2. Push the blower nozzle in fully and turn the blower
nozzle to lock it to the product.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks. Use a
brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
788 - 002 - 25.02.2020

Assembly

To adjust the harness
1. Put the hip pad straps through the fastenings in the
harness for the backpack battery.
2. Adjust the harness to optimize the work position.

Operation

Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
Backpack battery (530iBX)
The backpack battery capacity is shown with digits on
the product and the LED lamps on the backpack battery.
9