Maintenance Schedule; To Stop The Product :580Bts Mark; To Stop The Product :580Bfs Mark; Maintenance - Husqvarna 580BTS Mark II Manual Del Usuario

4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
6. Put your right foot on the frame.
7. Pull the starter rope handle slowly until resistance
occurs.
8. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
9. Move the choke lever to the open choke position
until the choke lever stops.
10. Pull the starter rope handle repeatedly until the
engine starts and continues to run.
11. If the engine does not start, do step 1 to step 10
again.
12. Let the engine run for 2-3 minutes to become warm
before operation.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surface.
Make sure that the throttle control operates correctly.
Make sure that the stop switch operates correctly.
Do a check of the stop switch, refer to
page 13 .
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the air filter. Replace if it is necessary.
936 - 004 -
To stop the product :580BTS Mark II
1. Push the throttle lever to the stop position.
To stop the product :580BFS Mark II
1. Push the stop switch.
Maintenance
To stop the product :580BTS Mark II on
CAUTION: Do not stop the product at full
speed.
CAUTION: Do not stop the product at full
speed.
Daily Weekly
X
X
X
X
X
X
Monthly
13