To Adjust The Harness - Husqvarna 580BTS Mark II Manual Del Usuario

3. Attach and tighten the bolt, washer and nuts as
shown in the illustration.
4. Attach the control pipe (B) to the flexible tube (A)
with the clamp (D). Make sure that the mark on the
control pipe is up.
5. Attach the intermediate pipe (F) to the control pipe.
6. Attach the blower nozzle (G) to the intermediate
pipe.
7. Loosen the knob (H) to adjust the position of the
handle.
10
H
8. Tighten the knob again.

To adjust the harness

A correctly adjusted harness and product makes
operation easier.
1. Put on the harness of the product.
2. Tighten the side straps until the product is tight
against your body.
3. Connect the chest strap to the clip.
4. Tighten the strap.
936 - 004 -