Loading Top Rack - Sears Kenmore ULTRA WASH 665.1602 Serie Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The toprack isdesigned forcups, g lasses, andsmaller items.
Many items, upto11"(28cm), f it inthetoprack. ( See
recommended
loading p atterns shown.)
NOTE: The features onyour d ishwasher
rack may vary from the
drawings shown.
Cup shelves (on some models)
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
shown below.
!0 place setting
!2 place setting
Place items so open ends face down for cleaning and
draining.
Load glasses in top rack only. The bottom rack is not
designed for glasses. Damage can occur.
Place cups and glasses in the rows between tines. Placing
them over the tines can lead to breakage and water spots.
China, crystal, and other delicate items must not touch each
other during dishwasher operation.
Damage may occur.
Load lightweight plastic items in the top rack only. Only
plastic items marked "dishwasher
safe" are recommended.
Load plastic items so the force of the spray does not move
them during the cycle.
To avoid chipping, do not let stemware touch other items.
Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Utensil basket (on some models)
Use this extra capacity basket in the back of the top rack to hold
spatulas, wooden spoons, and similar items.
Deluxe adjustable 2-position top rack (on some models)
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate
items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate
items up to 11" (28 cm) in
both the top and bottom racks. Adjusters are located on each
side of the top rack.
To raise the top rack
Lift the rack on both sides until the rack is level.
NOTE: The top rack must be level.
To lower the top rack
Depress both tabs on rack adjusters, as shown above, and slide
the rack back to its original position.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido