Operating Your Appliance; Operating Your Electric Cooktop - Avanti BCT115J1B-IS Manual De Instrucciones

Cocina electrica

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Ø CONTROL PANEL

Control Panel Lock Button

Front Burner Selector Button

Reduce / Decrease ( - ) Button

Timer Selector Button

Add / Increase ( + ) Button

POWER ON / OFF BUTTON

Push this button to turn the cooktop power on or off,

BURNER SELECTOR BUTTONS (FRONT BURNER / REAR BURNER)

Press the appropriate button for the desired burner.

Once pressed the burner display will show the default setting ( 5 = Medium), adjust to the desired

cook temperature using the ( - ) or ( + ). The temperature setting ranges from 0 – 9. The setting will

blink or flash in the display indicating it is in setting mode. Once you have selected the desired

temperature simply press the button for the selected burner or leave the control panel alone for

approximately for 3 seconds, the setting will stop blinking in the display window.

Example of comparable temperature ranges:

1 – 2

No Heat

Low Heat

AUTOMATIC SHUT OFF TIMER

Press to set a pre-set cook time, press the Timer button and then set the desired cook time using the

( - ) or ( + ) buttons. The default time is 10 minutes.

Press the button for the desired burner (front or rear), then select the desired cook temperature setting

using the ( - ) or ( + ) buttons.

Press the timer button (10 will appear in the display window as 10 minutes is the default), set the

desired cook time by pressing the ( - ) or ( + ) buttons (time ranges between 0 – 99 minutes).

The ( • ) next to the temperature setting in each window will turn on to indicate the timer has been set

for that burner.

Once set, the unit will automatically shut off after the cook time has expired.

HOT SURFACE INDICATOR

After the burner is used and turned off, the display will flash ( H ) to warn that the surface is still hot.

Once the burner and surface has cooled down the ( H ) indicator will turn off automatically.

Each burner will show the ( H ) warning respectively.