Problems With Your Dishwasher; Troubleshooting Guide - Avanti DW18 Manual De Instrucciones

You can solve many common dishwasher problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Dishwasher does not
The circuit breaker tripped or blown
operate.
fuse.
Power supply is not turned on.
Water pressure is low.
Drain pump doesn't Overflow
stop
Noise Some audible sounds are normal.
Utensils are not secure in the racks or
something small has dropped into the
rack.
Motor hums.
Suds in the tub Improper detergent.
Spilled rinse agent.
Stained tub interior Detergent with colorant was used.
Some tomato-based foods can stain
Dishes don't dry Rinse agent dispenser is empty.
Low inlet water temperature.
Dishes and flatware Improper program.
not clean. Improper rack loading.
Low inlet water temperature.
Cloudiness on Combination of soft water and too

PROBLEMS WITH YOUR DISHWASHER?

TROUBLESHOOTING GUIDE

POSSIBLE CAUSES
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely.
Make sure the power cord is properly
connected.
Check that the water supply is connected
properly and the water is turned on.
The system is designed to detect an overflow.
When it does, it shuts off the circulation pump
and turns on the drain pump.
Sound from soft food shredding action and
detergent cup opening.
Ensure everything is secured in the
dishwasher.
Dishwasher has not been used regularly. If
you do not use it often, remember to set it to
fill and pump out every week, which will help
keep the seal moist.
Use only the special dishwasher detergent to
avoid suds.
To remove suds from the tub, open the
dishwasher and let suds evaporate.Add 1
gallon of cold water to the tub. Close and
latch the dishwasher, pump out water by
slowly turning the dial until a drain period is
reached. Repeat if necessary.
Always wipe up rinse agent spills
immediately.
Make sure that the detergent is the one
without colorant.
Use of the RINSE ONLY cycle after adding
the dish to the load can decrease the level of
staining.
Check the rinse agent dispenser.
Make sure inlet water temperature is correct.
Select a stronger program.
Make sure large dishware does not block the
detergent dispenser or the wash arms.
Make sure inlet water temperature is correct.
This is called etching and is permanent. To
15
WHAT TO DO