Avanti BD6000 Manual De Instrucciones página 12

Castors with Lock Installation Sketch
?
Remove the 4 castors from one of the boxes inside the unit. Install the two castors with metal
bracket at the front designated positions of the cabinet base and the rest two castors at the rear
designated positions (Four screw holes pre-supplied).
?
In order to release or lock the brake, follow the below guide.
Installation of CO Cylinder Holder
2
?
Install the metal holder provided onto the 4 studs located on the
exterior back wall. Align the holes in the holder with the studs and
push down firmly. (See Figure 1)
Installation of CO Cylinder
2
?
Install your fully charged cylinder into the holder stand.
Installation of CO Regulator
2
?
Attach the CO regulator to the cylinder by turning the regulator nut
2
onto cylinder valve, making sure washer is securely inserted into
connecting nut. Tighten snug using an adjustable wrench (not
supplied) and assure there are no leaks. (See Figure 2)
Metal
Bracket
12
Figure 1
Figure 2