Beper 90.493A Manual De Instrucciones página 33

Bread Maker Use instructions
PROBLEM
Bread Did Not Bake Thoroughly
Solution: Do not open lid during final rising and baking cycle.
Cause 1: Lid was opened during baking.
Cause 2: Ingredients were not measured correctly.
Solution: Measure carefully, remembering to level off all cup and spoon measurements of dry ingre-
dients.
Cause 3: Machine is being used in a very cold room.
Solution: Only use appliance in warm location.
Cleaning and Storage
Disconnect the machine from power outer and allow it cool down completely before you start to
clean it.
1.Clean the inside of the machine with a damp, slightly soapy dish cloth. Wipe over again with a
clean damp cloth to remove any of the soapy residue.
2.To clean the Bread Pan. Rub the inside and outside of the pan with a damp cloth. Kneading Bar: If
the kneading bar is difficult to remove from the axle, soak the bread pan in water beforehand.
3.Lid and window: Clean the lid and machine inside outside with a slightly damp cloth.
Note: DO NOT use abrasive or strong household cleaners as these will damage
the non-stick surface of the Bread Maker.
Technical data
Power: 700W
Power supply: 220-240V~50 Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
33