Lubricating Cutting Equipment - Husqvarna 120i Manual De Instrucciones

• Turn the knob anti clockwise to loosen the drive
sprocket cover. (Figure 29)
• Adjust the tension on the chain by turning the chain
tensioner wheel down (+) for tighter tension and up (-
) to loosen the tension. (Figure 30)
• Tighten the bar clutch by turning the knob clockwise.
(Figure 31)
• Fold the knob back in to lock the tensioning. (Figure
32)

Lubricating cutting equipment

WARNING! Poor lubrication of cutting
!
equipment may cause the chain to snap,
which could lead to serious, even fatal
injuries.
IMPORTANT!
A worn bar and chain can stress the product to over
temperature. You should make sure to work with a well
maintained bar and chain to avoid this.
Chain oil
Chain oil must demonstrate good adhesion to the chain
and also maintain its flow characteristics regardless of
whether it is warm summer or cold winter weather.
Never use waste oil! Using waste oil can be dangerous
to you and damage the machine and environment.
Filling with chain oil
• Always use mineral based chain oil. (Figure 33)
• Contact your service agent when choosing chain oil.
• All our chain saws have an automatic chain lubrication
system. On some models the oil flow is also
adjustable.
• The saw chain oil tank is designed to last aproximately
three battery charges. However, this safety feature
requires that you use the right sort of chain oil (if the
chain oil is to thin it will last shorter time).
• Never use waste oil. This results in damage to the oil
pump, the bar and the chain.
• It is important to use oil of the right grade (suitable
viscosity range) to suit the air temperature.
• In temperatures below 0°C (32°F) some oils become
too viscous. This can overload the oil pump and result
in damage to the oil pump components.
Checking chain lubrication
• Check the chain lubrication every third battery charge.
Aim the tip of the bar at a light coloured surface about
20 cm (8 inches) away. After 1 minute running at 3/4
throttle you should see a distinct line of oil on the light
surface. (Figure 34)
If the chain lubrication is not working:
18 – English
GENERAL SAFETY PRECAUTIONS
• Check that the oil channel in the bar is not obstructed.
Clean if necessary. (Figure 35)
• Check that the groove in the edge of the bar is clean.
Clean if necessary. (Figure 36)
• Check that the bar tip sprocket turns freely and that
the lubricating hole in the tip sprocket is not blocked.
Clean and lubricate if necessary. (Figure 37)
If the chain lubrication system is still not working after
carrying out the above checks and associated measures
you should contact your service agent.
Chain drive sprocket
The drive system is fitted with a drive sprocket. (Figure
38)
Regularly check the degree of wear on the drive sprocket.
Replace if wear is excessive.
Checking wear on cutting equipment
Check the chain daily for:
• Visible cracks in rivets and links.
• Whether the chain is stiff.
• Whether rivets and links are badly worn.
Replace the saw chain if it exhibits any of the points
above.
We recommend you compare the existing chain with a
new chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to
only 4 mm the chain must be replaced.
Guide bar
Check regularly:
• Whether there are burrs on the edges of the bar.
Remove these with a file if necessary. (Figure 39)
• Whether the groove in the bar has become badly
worn. Replace the bar if necessary.
• Whether the tip of the bar is uneven or badly worn. If
a hollow forms on the underside of the bar tip this is
due to running with a slack chain. (Figure 40)
• To prolong the life of the bar you should turn it over
daily. (Figure 41)