To Fill The Fuel Tank; To Start The Engine - Husqvarna 525HF3S Manual De Usuario

Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
1118 - 002 - 23.12.2019

To fill the fuel tank

1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
4. Remove the fuel tank cap slowly to release the
Two-stroke oil,
liter
5. Fill the fuel tank.
2% (50:1)
0.10
0.20
6. Tighten the fuel tank cap carefully.
0.30
7. Move the product 3 m/10 ft or more away from the
0.40
Note: To see where the fuel tank is on your product,
refer to

To start the engine

1. Set the choke control in the choke position.
fully mixed.
pressure.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
refueling area and fuel source before you start the
engine.
Product overview on page 2 .
WARNING: Keep a minimum distance of 15
m/50 ft from persons or animals when you
start the product. There is a risk that the
cutting unit starts to move.
9