Unpacking Your Refrigerator; Supplied Parts; Required Tools - Sears Kenmore ELITE 41002 Guía Para El Uso Y Cuidado

Excessive Weight Hazard
Use two or more people to move and install the
refrigerator. Failure to do so can result in back or
other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from the
refrigerator before using. Do not remove any warning-type
labels, the model and serial number label, or the tech
sheet that is attached to the back wall of the refrigerator.
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleansers to remove tape or glue.
These products can damage the surface of the
refrigerator. For more information, see the 'Important
Safety Instructions" section.
Refrigerator shelves are installed in the shipping position.
Please reinstall the shelves according to your individual
storage needs.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure to protect
the floor. Always pull the refrigerator straight out
when moving it. Do not wiggle or walk the
refrigerator when trying to move it, as floor damage
could occur.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from the refrigerator. Failure to do so
can result in death, explosion, or fire.
o To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
o Select a place where a water supply can be easily
connected for the automatic icemaker.
Avoid placing the refrigerator near a heat source,
direct sunlight, or moisture.
SUPPLIED PARTS
The following parts should be supplied with the
refrigerator. Please verify before installing.
Water filter Hex wrench Screw
(DA29-00003B) (DA80-00002C) (6001-000541)
REQUIRED TOOLS
The following tools are needed to install and adjust the
refrigerator.
Phillips-head Flat-head Wrench
screwdriver screwdriver
|
Pliers Allen wrench (3/!6")
10