Push Buttons Functions; Display Information - Domus DTA-11 Manual De Usuario

4.4.

Push buttons functions

Pressing the different push buttons causes changes in the conditions of the machine. Below the
uses are explained.
Button State of machine
Select Program Selection
Temperature Selection
Time Selection
Machine Running.
Temperature selection
Machine Running
Humidity selection
In case of alarm
Arrows Program selection
Temperature selection
Humidity selection
Prog. (x3) Machine stopped
4.5.

Display information

be shown.
Display
PSM / v156
END
AL-X
(2) The End of cycle / Uncrease step lasts till 99 minutes. During this step each minute the
buzzer sound and the drum moves for some seconds. This situation end when the user opens
the door. After 99 minutes the machine returns on the stand-by situation.
DTA-DTP-11-18-27_Manual_ML
Display
P01
60º
25'
60º
25'
AL-3
P01
60º
25'
State of machine
Electrical connection
End / Uncrease action
Alarm
Go to temperature selection
Go to humidity selection
Go to program selection
Go to humidity selection.
Go to normal running state
Reset the alarm
Increase / decrease program number
Increase / decrease temperature
Increase / decrease humidity
(3 times) Goes in to programming mode
The display shows different information as per the
introduction of data and the state of the machine
at that moment.
Once the machine is running the % flashes.
Once the heating is On, an arrow appears near
the thermometer.
The following table shows each possible type of
information and the conditions in which they would
Comments
Shows version of software
End of cycle / Uncrease step
Show alarms (See point 3)
Action
(2)
Página 51 de 109