Every 800 hours
1. Change the hydraulic oil.
2. Replace the hydraulic tank breather cap.
3. Change the radiator fluid.
4. Drain and clean the fuel tank.
5. Clean and lubricate the pivot wheel housing.
6. Change the Inner air filter element.
7. Check the wear on the mast carriage side thrust pads and adjust if necessary.
8. Check the wear on the rotator thrust pads and adjust if necessary.
9. Check the wear on the horizontal carriage thrust pads and adjust if necessary.
10. Check the wear on the mast rollers.
11. Check the engine mounts.
12. Check the engine valve clearance.
13. Check the carriages.
14. Check the condition of the wheels and tires.
15. Check the hydraulic movement speeds.
16. Check the carriage attachments.
17. Replace the fan belt.
Every 1500 hours
1. Check the engine EGR cooler.
2. Check the engine PCV valve.
Every 2400 hours
1. Check the hydraulic circuit pressures and discharge rates.
2. Check the hydrostatic transmission circuit pressures.
3. Insure the transmission cut-off / Parking brake valve is in
good working order.
4. Check the steering system.
5. Clean the hydraulic oil tank.
6. Check the engine fuel injectors.
7. Check and clean the radiator.
8. Check the water pump and thermostat.
9. Check the mast and carriage assemblies.
10. Check engine turbo charger.
Every 4800 hours
1. Check the rear wheel motor pivot.
2. Check the steering pins and bushings.
3. Check the alternator and the starter motor.
Bright Forklift
BC3–6560
Maintenance Instructions
35