Functional Description; Removing/Inserting The Battery - Milwaukee 2522-20 Manual Del Operador

SPECIFICATIONS
Cat. No. ..................................................... 2522-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
RPM ..............................................................20,000
Wheel Size .......................................................... 3"
Arbor Size ............................................3/8" or 7/16"
Maximum Wheel Thickness .............................. 1/8"
Maximum Cutting Depth ................................. 0.64"
Recommended Ambient
Operating Temperature ......................0°F to 125°F

FUNCTIONAL DESCRIPTION

7
8
1. Guard
2. Spindle lock (behind guard)
3. Control switch indicator
4. Control switch
5. Handle
6. Trigger
7. Dust extraction attachment
8. Dust shoe assembly
9. Shoe release button
10. Depth of cut gauge
11. Depth of cut wing nut
12. Top flange
13. 3/8" bottom flange
14. 7/16" bottom flange
15. Centering hub
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
6
9
10
11
12
13
14
15
5
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Wheel Selection
To reduce the risk of injury, only
WARNING
use Type "1" abrasive and diamond
wheels with a maximum 1/8" thickness, rated with
a maximum safe operating speed at least
20,000 RPM. Type 1 wheels are for side grinding
only, not surface grinding. Read all safety infor-
mation supplied with cut-off wheels.
Always wear proper safety equipment, including a
dust mask. Protect everyone in the area from sparks.
Use the chart below to choose the correct wheel.
Different types of wheels work best for different
materials. Follow the use recommendations from
the wheel manufacturer.
Wheel Type:
Carbide Abrasive
Wheel
Abrasive Cut-off
wheel
Diamond Abrasive
Wheel
To reduce the risk of injury, use
WARNING
only the proper wheel made for this
tool. Do NOT use any type of saw blade. Use only
abrasive and diamond wheels. To ensure the
wheel is properly secured, always use the mount-
ing hardware supplied with your tool.
Do not touch the cut-off wheel or workpiece
immediately after cutting; they may be hot and
could burn skin.
Installing and Removing Cut-Off Wheels
Before operating the tool, make sure the wheel is in
good condition (see "Specific Safety Rules").
3/8"
bottom
flange
Guard
Spindle
Spindle
lock
1. To install cut-off wheels, remove the battery pack.
2. Place tool on a firm surface with the guard surface
facing up.
Recommended for Cutting:
Drywall, Fiber Cement,
Plastic
Steel, Stainless Steel,
Non-Ferrous Materials
Tile, Ceramics
Bolt
Top
flange
Cutting
wheel
centering
hub
7/16"
bottom
flange