Yamaha M-5000 Manual De Instrucciones página 7

NOTICE
Make sure that the impedance of each speaker is
appropriate for the system configuration . For more
information, refer to "Basic speaker connections"
(page 14), "Bi-wiring connections" (page 18), "Bi-
amp connections" (page 20), and "Bridge connections"
(page 22) .
C. Meter display (LEFT/RIGHT)
Indicates the audio output level of the left and right
channels.
D.
METER selector
Switches the meter display type to OFF, PEAK, or VU.
DIMMER: Adjusts the brightness of the meter display.
The brightness will change slowly between the brightest
and darkest (off). When you select the meter type by
turning the METER selector, the brightness at that point
will be used for the display.
OFF: Turns off meter operation and display illumination.
METER INPUT
PEAK BAL
OFF LINE
VU
DIMMER
PEAK: Switches the meter display type to a peak
level meter. The peak level meter shows the highest
instantaneous level of an audio output signal.
VU: Switches the meter display type to a VU (Volume
Unit) level meter. The VU level meter shows an effective
audio output value that represents the way sound is
perceived by human ears.
E. INPUT selector
Enables you to select jacks to play back an audio source.
LINE: Audio source input from the LINE jacks will be
played back.
BAL: Audio source input from the BAL jacks will be
played back.
7