Connections; Connecting To A Network - Yamaha MusicCast SUB 100 Manual De Instrucciones

CONNECTIONS

Connecting to a network

Preparations for network connection
This unit can be connected to a network either via a cable or wirelessly. Choose the connection method that's appropriate
for your situation.
If connecting wirelessly
Make settings so that this unit can communicate wirelessly.
1.
Set the rear panel INPUT switch to NET.
2.
Set the rear panel WIRELESS switch to
AUTO.
NOTICE
Do not connect a network cable to the NETWORK
port. If a network cable is connected, the wired
connection takes priority and wireless connection is
not possible.
(rear panel)
2
Powering-on this unit
1.
Insert the power cord plug into an AC
outlet.
(rear panel)
to an AC outlet
NOTE
● If the network is starting up, the STATUS indicator on the top panel flashes green.
● If you're using a wired connection, the LED on the inside of the NETWORK port flashes when connected to the router.
NOTICE
● When turning on the power in your audio system, always turn on this unit last.
12
En
1
If connecting via a cable
Use a commercially available STP network cable (CAT-5
or higher straight cable) to connect this unit to your router.
1.
Set the rear panel INPUT switch to NET.
2.
Set the rear panel WIRELESS switch to OFF.
3.
Connect a network cable to the
NETWORK port.
NOTICE
If you want to connect this unit via a wired connection
and play back music, all of the MusicCast Surround/
Stereo compatible devices that you want to link (such
as a sound bar or a wireless streaming speaker) must be
connected via a wired LAN.
(rear panel)
2
2. Press the rear panel A (STANDBY/ON)
button to turn on the power of this unit.
3
1
(rear panel)