Power Connection; Operation - myaudioart MA5 Manual De Instrucciones

Power connection

If the mains cable was not connected before mounting the system, you need to
connect it to the power supply before the system can be powered on. Only use the
provided mains cable and do not lengthen it.
As an alternative to standard power supply using the included mains cable, you can
power the system using a suitable 12 V DC battery.
Do not use both electrical connections at the same time! If you alternate between
those electrical connections, disconnect the connection that is not used.
Power supply
– Connect the rubber connector of the mains cable to the 220V AC input
(see page 45).
– Connect the safety plug to the power socket.
Battery connector
Risk of severe damage through reversed polarity!
ATTENTION
Connecting the wrong cables (reverse polarity) can
cause servere damages to the system. Ensure correct
allocation of the cables.
– Take the screw terminal off the 12V DC input (see page 45).
– Insert the battery cables into the correct terminals and tighten the screws.
– Insert the screw terminal into the 12V DC input and use the master switch to turn
on the system.
– If the connection line is reverse-poled, the LED POWER lights up orange. In this
case, immediately disconnect the system from the battery!
44

Operation

Control elements, connections and displays
All control elements and displays are integrated into the side of the frame. The remote
control is described on page 47.
User Manual User Manual
SOURCE Button: Choose audio source
BLUETOOTH LED: Status of the Bluetooth
WIRELESS Button: Choose AudioFly
connection, LED: Status of AudioFly
Syncronice connection
®
SOUND SETUP Button: Choose sound setup
LED: chosen sound setup
BRIGHTNESS + Button: Increase ambient light brightness
BRIGHTNESS - Button: Decrease ambient light brightness
LEDs: Indicate volume and active input
VOLUME + Button: Increase volume
VOLUME - Button: Decrease volume
INPUT 2 3.5 mm (0.14'') jack connector (stereo):
Connector for audio source
SUB-OUT 3.5 mm (0.14'') jack connector (mono):
Connector for subwoofer
INPUT 1 Cinch connectors:
Connector for audio source
(L = left channel, R = right channel)
POWER LED: System status
12 V DC Screw terminal: Battery connector with
12 V DC
ON / OFF Main switch: Switch the system on and off
220 V AC IEC socket: Connector for the mains
cable
connection
®
/Syncronice
® ®
® /
45