Troubleshooting; Led Colors And Signals - myaudioart MA5 Manual De Instrucciones

Troubleshooting

The following table is intended to help you identify the causes for malfunctions and
possibly eliminate them.
If you cannot fix a malfunction, please contact your local specialized dealer or our
engineering department. You can contact us per email via info@myaudioart.com or
under +49 2972 974 933 0.
Problem Possible reason
The system cannot be Mains cable is not
switched on using the main connected.
switch.
The toggle switch on the
rear is not set correctly.
The system does not react Battery is low or empty.
to remote control.
Obstacle between remote
control and system.
No playback. Volume is set too low.
Playback device or smart
phone is switched off.
Pause is selected.
Interruptions during Distance between system
playback. and playback device is too
great.
Source of interference
in the surrounding
environment.
Sound comes only from When using audio cables:
one side. loose connections.
Playback volume too low or When using an audio
overmodulated (distortion). cable: Input sensitivity not
58
Recommended solution
Check if both ends of the
mains cable are connected
properly.
Flip the toggle switch
(see page 43).
Change battery
(see page 56).
Change position.
Turn up volume.
Switch on device.
Start playback.
Reduce distance.
Change location of
playback device.
Check audio cable and
firmly connect plug.
Adjust input sensitivity
(see page 51).
User Manual

LED Colors and Signals

LED signals provide information about the system status and the different settings
and functions.
The following table shows the LEDs from top to bottom (see page 45).
LED Signal
BLUETOOTH flashing red and green
flashing green 1:1
flashing green 2:1
WIRELESS solid red (bright)
solid red (dark)
solid green
SOUND SETUP solid green
solid orange
solid red
no description solid red
WIRELESS solid orange
BLUETOOTH solid orange
INPUT 3 solid green
INPUT 2 solid green
INPUT 1 solid green
POWER solid green
solid orange
solid red
The LEDs are automatically switched off after a short while to prevent interfering with
other lighting. However, they are turned back on automatically when operating the
system.
User Manual
Meaning
Pairing ready (see page 48)
Aktive, not connected
Connected
Searching devices
Connected, not saved
Connection saved
Sound setup 1
Sound setup 2
Sound setup 3 (see page 50)
Volume
(see page 49)
Audio source
(see page 49)
System switched on
Input overmodulated or 12 V
connection reverse-poled
Error
59