Filter System; Error Codes - Danby DDW1804EW Manual Del Propietário

CARE & MAINTENANCE

FILTER SYSTEM

The fi lter system removes food particles from
the wash water and traps them. It is highly
recommended to empty and clean the fi lters after
every wash cycle.
To clean the fi lter system:
1. Turn off the dishwasher. Turn the fi lter and lift
upwards to remove the fi lter system from the
appliance.
2. Rotate the fi lter insert counterclockwise to
unfasten and then detach the fi lter insert.
3. Rinse and clean the fi lters with water and
replace them inside the appliance.
1
2
3
SPRAY ARM
The spray arm can be removed from the appliance
by pulling gently upwards. Rinse the spray arm with
warm water to remove any debris that can clog the
nozzles. Replace the spray arm in the appliance by
pushing downward until it clicks into place. Ensure
that the spray arm movement is not impeded before
running another cycle.

ERROR CODES

E1: Water intake is restricted or water pressure is
too low.
E3: Malfunction of heating element
E4: Water overfl ow
If the appliance displays any error code, a power
reset may resolve the issue. Unplug the appliance,
wait approximately 5 minutes and then plug the unit
back in.
12