AKO 16624 Guía Rápida página 15

Description
Shows temperature
Shows relative moisture /
hour (in line with b23)
Keypad
Indicators
Constant: Stand-By Mode activated. Regulation
is paused.
Flashing: Controlled stop process for the
regulation in progress.
Constant: Cold room door open.
Flashing: The door has been open for a longer
time than defined in parameter A12.
There is an active alarm, but not an active HACCP
alarm.
Constant: HACCP alarm active.
Flashing: HACCP alarm recorded and
unconfirmed. Press the
HACCP alarm.
There is an active alarm relating to the
temperature or moisture probes.
Constant: Evaporator fans active.
Flashing: The evaporator fans should be active
but a delay is preventing this.
Constant: The cold solenoid is active.
Flashing: The solenoid should be active but a
delay or protection is preventing this.
Constant: Compressor active.
Flashing: The compressor should be active but a
delay or protection is preventing this.
Active heat provision, whether via evaporator
resistors or Hot Gas.
Humidifier relay active.
Defrost relay active.
Continuous cycle mode active.
Cold room light active.
Alarm in progress muted.
Temperature displayed in ° Fahrenheit /
º Centigrade.
Programming mode active.
key to confirm an
Dehumidifier relay active / virtual control relay
AUX
active.
The lower display shows the relative moisture
value.
Constant: CAMM module in operation.
Flashing: Malfunction in CAMM module.
Bluetooth activated (only with CAMM module).
15 15
1662H411 Ed.01
AUX