Self-Cleaning - Samsung NX36R9966P Serie Manual De Uso

Gas oven

Self-cleaning

This self-cleaning oven uses high temperatures (well above cooking temperatures)
to burn off leftover grease and residue completely or to reduce them to a finely
powdered ash that you can wipe away with a damp cloth.
CAUTION
• Do not leave small children unattended near the gas oven during the self-
cleaning cycle. The outside surfaces of the gas oven can get extremely hot.
Some birds are extremely sensitive to fumes from a self-cleaning gas oven.
•
Relocate birds to a well-ventilated room away from the gas oven.
• Do not line the oven, oven racks, or oven bottom with aluminum foil. Doing
so will result in poor heat distribution, produce poor baking results, and cause
permanent damage to the oven interior. The aluminum foil will melt onto and
adhere to the interior oven surfaces.
• Do not force the oven door open during the self-cleaning cycle. This will
damage the automatic door-locking system. The door automatically locks
when the self-cleaning cycle is started and stays locked until the cycle is
completed or cancelled and the oven temperature is below 400 °F.
• Use caution when opening the oven door after the self-cleaning cycle. The
gas oven will still be VERY HOT and hot air and steam might escape when the
door is open.
• Wipe off any excess spillage before using the self-cleaning operation.
• Do not use oven cleaners. Commercial oven cleaners or oven liners should
NEVER be used in or around any part of the oven. Residue from oven cleaners
will damage the inside of the oven during a self-cleaning operation.
• Both knobs must be in the OFF position initially before you set the mode
selector knob to the Clean position.
30 English
NX9900R_CHEF_NX36R9966PS_AA_DG68-01105A-01_EN+MES+CFR.indb 30
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks (Flat rack, Gliding rack,
Ladder rack) from the oven cavity.
1.
2.
3.
Mode Selector Knob
4.
Set Clean Time
3hr
5.
Set Clean Time
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle. If you attempt to start a self-cleaning cycle while using the surface burners,
a message appears warning you to turn off the surface burners. If you attempt to
use the surface burners during a self-cleaning cycle, a message appears warning
you to turn off the burners. Also, the temperature knob light blinks orange for
10 seconds. If you do not turn off the burners within 10 seconds, the self-cleaning
cycle is cancelled.
Make sure the oven door is unlocked
and closed completely.
Turn the mode and temperature
selector knobs to the OFF position.
Then, turn the mode selector knob from
OFF to the Self Clean position.
Set the self cleaning time. 3hr is the
default. Press <, > to select another time
set. Press OK to start Self Cleaning.
The oven door is locked and the oven
begins to heat up. When the cycle is
complete, an alert beep sounds. The
door will remain locked until the oven
temperature falls below 400 °F (205 °C).
When the Self-Cleaning cycle is
complete, turn the mode selector knob
to the OFF position.
2019-03-08 12:33:13