Cleaning; Gliding Rack - Samsung NX36R9966P Serie Manual De Uso

Maintenance

Cleaning

Stainless steel surface
1. Remove any spills, spots, and grease stains using a soft, wet cloth.
2. Apply an approved stainless steel cleanser to a cloth or paper towel.
3. Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4. When done, dry the surface using a soft, dry cloth.
5. Repeat steps 2 through 4 as many times as necessary.
CAUTION
• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
• Do not spray any type of cleanser into the manifold holes. The ignition system
is located in those holes and must be kept free of moisture.
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour impurities off of the racks using a plastic scouring pad.
If the racks do not slide in and out smoothly after you have cleaned them, rub the
side rail guides with wax paper or a cloth containing a few drops of cooking oil.
This will help the racks glide more easily on their tracks.
40 English
NX9900R_CHEF_NX36R9966PS_AA_DG68-01105A-01_EN+MES+CFR.indb 40

Gliding rack

1.
2.
3.
To apply the graphite lubricant
1.
2.
3.
4.
Remove the gliding rack from the oven.
Fully extend the gliding rack on a table.
It is a good idea to put newspaper
beneath the rack for later cleanup.
If the sliding tracks are contaminated,
remove impurities using a paper towel.
If the gliding rack has been sticking,
apply graphite lubricant according to
the instructions below.
Shake the graphite lubricant before
opening it.
Apply 4 drops of lubricant to the inner
side of the left sliding track and 4 drops
to the outer side of the left sliding
track.
Repeat Step 2 above on the right
sliding track.
Extend and collapse the gliding rack
several times to distribute the lubricant.
2019-03-08 12:33:15