Brewing - Cuisinart SS-5 Manual De Instrucciones

Brewing

1. Remove water reservoir to fill.
2. Add water into the 40-ounce water
reservoir. Replace on unit.
3. Press the Power button.
4. The Power and Brew buttons will
illuminate.
5. Place mug on the drip tray. The drip
tray can be removed to accommodate
travel mugs.
6. Select a capsule.
Note: Do not remove the foil lid or
puncture the capsule.
7. Open the brew head and place a
capsule in the brewing chamber.
Caution: There are two sharp
needles in the brewing chamber
that puncture the capsule, one
above and one below. To avoid
risk of injury, do not put your
fingers in the capsule brewing
chamber.
8. Press the desired brew button
(6, 8, or 10 oz.). The beverage will start
to dispense momentarily. Selected brew
button will flash while brewing.
Note: To cancel brewing, simply press
the selected brew size once again and
the brewing process will be stopped.
Caution: There is very hot water
in the capsule chamber during
the brewing process. To avoid
risk of injury, do not lift the handle
or open the capsule chamber
during the brewing process.
9. Once fully dispensed, all lights will
illuminate. Lift the handle, then remove
and dispose of the used capsule. Close
the brewing head.
Caution: Capsule will be hot.
10. Enjoy your cup of coffee! Your brewer
is ready to use again or you can power
it off.
Note: When Add Water LED starts to
flash, no brewing can be done. Once
you refill the reservoir, your unit is ready
to brew.
10