Brewing Coffee; Brew Pause Feature - Cuisinart Thermal Coffee Center SS-20 Serie Manual De Instrucciones

SETTING THE AUTO-ON TIME
When you turn the Function knob to PROG,
the previously selected Auto On time, or the
default time (12:00) will flash.
1. Turn the Function knob to PROG.
Hour and Minute buttons as above to program
your start-brew time.
2. Turn the Function knob to AUTO ON.
Press the BREW/WARM button to activate the
program. When you press BREW, the AUTO
ON blue light will illuminate, indicating the
AUTO ON function has been activated. LCD
will display the current time.
3. AUTO-ON brew cycle begins.
light around BREW will flash slowly when the
brew cycle begins at the time you have
selected. When the brew cycle ends, BREW
will come back on indicating the coffeemaker
is ready for the next brew.
NOTE: To start brew time at the same time
the next day, simply make sure the
Function knob is at AUTO ON and press
and release Brew button once more. The
blue Auto On light will turn on.
SETTING THE READY TONE ALERT
Set Ready Tone to ON for audible alert when
brew cycle is complete. Set to OFF for no
audible alert.

BREWING COFFEE

Follow instructions in Setting Up Your
10-Cup Coffeemaker on page 8.
1. Insert charcoal water filter
Follow directions for the preparation and
insertion of the filter on page 8.
2. Fill the water reservoir
Open the Coffeemaker reservoir cover by
lifting it up. Pour in the desired amount of
water, using the water level indicator located
at the side of the Coffeemaker.
3. Before brewing
Make sure the thermal carafe is in position on
the resting plate and the top cover is closed.
Plug the cord into an electrical outlet.
4. Set preferences
Push the BOLD button if would like a stronger
brew. BOLD button will illuminate.
5. Add the ground coffee
Remove the filter basket by grasping the
handle and lifting straight up. Insert a #4
paper filter or permanent filter. Be sure that a
paper filter is completely open and fully
inserted in the basket. It may help to fold and
flatten the seams of a paper filter beforehand.
Add 1 level scoop of ground coffee per cup.
Adjust the amount according to taste.
NOTE: The maximum capacity for
ground coffee is 15 tablespoons for this
Use the
Coffeemaker. Exceeding this amount
may cause overflow if the coffee is too
finely ground.
Replace the filter basket in the filter basket
holder and press firmly on cover to be sure it
closes securely.
6. Brewing coffee
Turn the Function knob to BREW, press the
BREW button, and the blue indicator light will
The blue
flash slowly. Or, set the AUTO ON function
(see page 9) and the Auto On indicator will
light.
7. After brewing
When the brewing cycle has been completed,
coffee will continue to stream from the filter
for several seconds. When streaming
completely stops, five beeps will sound and
you can now enjoy your coffee.
NOTE: Reservoir cover may be hot during
and directly after brewing. Wait at least 10
minutes before opening.
This feature interrupts the flow of coffee
from the basket to let you pour that first
cup mid-brew. Because the flavor profile of
coffee brewed at the start of a cycle differs
from that brewed toward the end, be aware
that using this feature will weaken the flavor
strength of the finished pot.
NOTE: Removing carafe for more than 20
seconds may cause filter basket to overflow.
9
™
BREW PAUSE FEATURE