Troubleshooting Schedule - Husqvarna 136 LiHD50 Manual De Instrucciones

Troubleshooting schedule

Control panel
Troubleshooting takes place from the control panel.
LED display
Error LED flashes.
Error LED is lit with red light. Non repairable fault.
Battery and battery charger
Troubleshooting the battery and/or the battery charger during charging.
LED display
Error LED flashing.
Error LED is lit.
20 – English
MAINTENANCE
Possible faults
Overload.
Temperature deviation.
The power trigger and the
activate button are pressed
at the same time.
Possible faults Possible action
Use the battery in surroundings
Temperature
where temperatures are between -
deviation.
10 °C and 40 °C.
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Over voltage.
Remove the battery from the battery
charger.
Cell difference too
Contact your service agent.
much (1V).
Possible action
The cutting attachment is
jammed. Release the cutting
attachment.
Allow the machine to cool
down.
Release the power trigger
and the machine is active.
Contact your service agent.