Timer Function - Ambiano IK 4017 Manual Del Usuario

Timer function

An operating time of 2 hours is predefined both when operating the
device via power levels as well as when operating it via temperature
levels�
The device gives you the option to define a certain time period for operation� After
expiration of the defined time period, the device automatically switches off or goes
into standby mode; no heating process will occur at this time� During operation you
can change the specified time at any time by pressing the selector button
the selector button
If you want to use this function, please proceed as follows:
First select the power or temperature mode, depending on which mode you
would like to work in, and define the desired settings� Then briefly press the
button Timer/Lock
predefined time of 2:00 hours will start flashing� While the displayed number is
flashing, you can set the desired operating time (in 1 minute increments from
1 minute to max� 180 minutes (3:00 hours)) by pressing selector button
selector button 6
time it will be continuously lit� The set time will subsequently be counted down in
minute steps�
If you keep the selector button
start counting in 10 minutes increments�
The LED display 7 will thereby continuously switch from showing the time to
showing the defined power or temperature levels� You can change the settings you
made with regard to power or temperature levels at any time as desired; the device
will always work with the latest settings you entered�
To end the timer function before it has fully counted down, switch the
device off by pressing the on/off button
desired)�
8 ; the set power or temperature levels remain unchanged�
17 once to get to the timer mode� In the LED display, the
� The set time will be flashing and after a short period of
or pressed, the time will
8 6
(and switch off again, if
Operation
6 or
8 or
25