Operation With The 51070 Analog Locomotive Controller - LGB 55015 Manual De Instrucciones

decoders is programmed using CV1:
• The display shows
• Enter the number of the CV to be programmed:
example: 01. The display now shows
• Enter the desired address or function value,
example: locomotive address 05. The display
now shows ..
d -
• Store the programing with the
You can cancel the programming with the
button.
• If you have to reset all of the settings in the
programming to the factory default settings,
you must first change the programming mode
from "C" to "P".
• Press the button.
display.
Then please follow the information given in the
instructions for the item in question.
The 55020 MTS decoder can only be programmed
in the "P" programming mode.
After you are finished with all of the programming,
undo the cable or wire from the transformer and
the decoder or programming track. Remove the
programming module and put the original top part
back into the Universal Hand Controller.
8. Operation with the 51070 Analog
Locomotive Controller
You absolutely have to have the 55050/55055 LGB
radio control in order to use the Universal Hand
Controller here. See the instructions for these
conversion modules.
12
125963_55015_Universalhandy_A5.indd 12
.
--
.
d -
button.
will appear in the
P -
25.04.2013 13:17:16