Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 422
To achieve the best quality surround sound, you can use MANUAL SETUP to fine-tune the listening environment
parameters, as well as to make advanced settings for sound signals, sound beams, digital input, and the OSD. Change the
initial settings (indicated in bold under each parameter) to reflect the needs of your own listening environment.
y
• You can save the settings optimized by the AUTO SETUP procedure (see page 36). A set of settings optimized according to the
specific conditions of your listening environment can be recalled later depending on the varying conditions of your listening
environment (see page 37).
• Most of the parameters in SOUND MENU and BEAM MENU are automatically set when you run AUTO SETUP (see page 29). Use
SOUND MENU and BEAM MENU to make additional adjustments.
• BEAM MENU allows you to make settings for the surround sound effects normally available in the speaker settings menu.
• Make settings for the parameters in BEAM MENU first before making settings for the parameters in SOUND MENU, INPUT
MENU, and DISPLAY MENU.
SOUND MENU
Use to manually adjust the various parameters related to the sound output.
Item
TONE CONTROL
SUBWOOFER SET
MUTE LEVEL
AUDIO DELAY
DD/DTS Dynamic Range
BEAM MENU
Use to manually adjust the various parameters related to the sound beam output.
Item
SETTING PARAMETERS
BEAM ADJUSTMENT
IMAGE LOCATION
INPUT MENU
Use to manually adjust the various parameters related to the audio and video input.
Item
INPUT MODE
INPUT TRIM
INPUT RENAME
HDMI SET
DISPLAY MENU
Use to manually adjust the various parameters related to the display.
Item
F.DISPLAY SET
OSD SET
UNIT SET

MANUAL SETUP

Adjusts the output level of high-frequency or low-frequency sound.
Adjusts the various subwoofer settings.
Adjusts the muting level.
Adjusts the audio delay.
Adjusts the dynamic range of Dolby Digital or DTS signals.
Adjusts the listening room and listening position settings.
Adjusts the various sound beam settings.
Adjusts the sound position of the front left and right channels.
Selects the initial input of the source.
Adjusts the input level of the source.
Renames the displayed input source.
Adjust the various HDMI settings.
Adjusts the front panel display settings.
Adjusts the OSD settings.
Changes the display unit of measurement.
Features
Features
Features
Features
MANUAL SETUP
Page
59
59
59
59
60
Page
55
56
58
Page
60
61
61
62
Page
64
64
64
53
En

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido