Connection To Your Amplifier - Yamaha NS-C901 Manual De Instrucciones

Before making connection, make sure that the amplifier is switched off.
■ CONNECTIONS
You need a commercially available speaker cable.
y
The size and/or material of a speaker cable affects on the
sound quality. Therefore, we recommend you to purchase
a high-quality speaker cable to exert the performance of
this unit.
Notes
• Connect the (+) terminals on the amplifier and the
speaker using one side of the cable. Connect the
(–) terminals on both components using the other
side of the cable.
• Connect the speaker to the center terminals of your
amplifier, making sure not to reverse the polarity
(+, –). If the speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
• When using an amplifier with a rated output power
higher than the nominal input power of the speaker,
care should be taken never to exceed the speaker's
maximum input.
• The speaker may be damaged if certain sounds
are continuously output at high volume level.
For example, if sine waves from a test disc, bass
sounds from electronic instruments, etc., are
continuously output, or when the stylus of a
turntable touches the surface of a disc, reduce the
volume level to prevent the speaker from being
damaged.
• Please refer to the owner's manual that came with
your amplifier or receiver.
How to connect:
1 Loosen the knob.
2
R emove 15 mm (5/8") of insulation from each end of
the cables, and twist the exposed conductors together
neatly and tightly, as shown below.
15 mm
(5/8")
3 I nsert the bare wire in to the hole.
4
Tighten the knob and secure the cable.
5
T est the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
• Do not let the bare speaker wires touch each other
as this could damage the speaker or the amplifier,
or both of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.

CONNECTION TO YOUR AMPLIFIER

Loosen
Black (–)
Bare wire
CENTER
Amplifier
When using a banana plug
1
Unscrew the terminal knob.
2 R emove the cover by pulling it toward you.
2
Banana plug
Tighten
Red (+)
Insulation coating
NS-C901
+
–
1
2
En