Disposal Information; Before Using For The First Time - Bosch BX1 Instrucciones De Uso

en

Disposal information

Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation. It
is made of environmentally friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many valuable
materials. Therefore, please take your used vacuum
cleaner to your retailer or recycling centre to be
recycled. For current disposal methods, please
enquire at your retailer or your local council.
Disposal of filters and dust bags
Filters and dust bags are made from environmentally
friendly materials.
As long as they do not contain substances that are
not permitted to be disposed of in the household
rubbish, you can dispose of them with your normal
household rubbish.
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
10
Fold out picture pages.

Before using for the first time

1*
Figure
Push the handle onto the flexible hose until it engages.
Setting up
2
Figure
a) Push the flexible hose into the opening at the
front of the vacuum cleaner.
b) To remove the flexible hose, turn to release the catch and
pull the hose out.
3*
Figure
Push the handle into the fixed/telescopic tube.
To remove it, turn the handle slightly and pull it out of the
tube.
4*
Figure
Insert the fixed/telescopic tube into the floor tool.
To remove it, turn the tube slightly and pull it out of the
floor tool.
5*
Figure
a) Connect the fixed tubes together, or
b) Unlock the telescopic tube to adjust its length by
moving the sliding button in the direction
of the arrow.
6
Figure
Holding the power cord by the plug, pull out the required
length and plug the plug into the mains socket.
7
Figure
Press the on/off button in the direction of the arrow to
switch your vacuum cleaner on/off.
8
Figure
Adjust the suction by turning the on/off button in the
direction of the arrow.
Set the power setting to maximum for the best results
when vacuuming.