LG LTG4715 Serie Manual De Preparación página 56

56 TROUBLESHOOTING
Symptoms
The oven is not clean
after a Self Clean
cycle.
Clean and door flash
in the display.
"Loc" message
appears when you
want to cook.
Oven control beeps
and displays an F
error code.
The oven racks were
cleaned in a Self
Clean cycle.
Clock is flashing.
"Burning" or "oily"
odor emitting from the
vent.
Strong odor.
Fan noise
Fan operation
Burners are not
lighting properly after
cleaning the cooktop
surface.
When lighting just one
burner, clicking noise
is heard from all the
burners.
Wi-Fi network does
not connect properly.
Light can be seen
through the oven air
vents.
• Incorrect oven control settings. See Self Clean in the MAINTENANCE section.
• The oven was heavily soiled. Clean up heavy spills before beginning the Self
Clean cycle. Heavily soiled ovens may need either a longer Self Clean or two
Self Clean cycles.
• The self clean cycle has been selected, but the door is not closed.
- Close the oven door.
• Oven is too hot.
- Allow the oven to cool below locking temperature.
• Allow about one hour for the oven to cool after the completion of a Self Clean
cycle. The door can be opened when the lock
• The control and door may be locked.
• Check the main gas shut-off valve or
the oven gas shut-off valve and call
for service.
• Remove the power from the range
for five minutes and then reconnect
the power. If the function error code
repeats, call for service.
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the
oven racks. Do not use lubricant sprays.
Power outage or surge. Reset the clock. If the oven was in use, you must reset it
by touching the Upper Clear/Off or Lower Clear/Off key. Reset the clock and any
cooking function.
This is normal in a new oven. To speed the process, set a Self Clean cycle for a
minimum of three hours. See Self Clean in the MAINTENANCE section.
An odor from the insulation around the inside of the oven is normal for the first few
times the oven is used.
• A convection fan may automatically turn on and off.
- This is normal.
It is normal for the fan to operate periodically throughout a normal bake cycle in the
lower oven. This is to ensure even baking results.
Make sure that the burner heads and caps are completely dry and properly
positioned.
This is normal. Electric spark igniters from the burners cause the clicking noise. All
the spark igniters on the cooktop will activate when igniting just one burner.
• If the appliance is having trouble connecting to the Wi-Fi network, it may be too
far from the router. Purchase a Wi-Fi repeater (range extender) to improve the
Wi-Fi signal strength.
• The Wi-Fi connection may not connect or may be interrupted because of the
home network environment.
• The network connection may not work properly depending on the internet service
provider.
• The surrounding wireless environment can make the wireless network service
run slowly.
While the Broil function is running, it is normal to see a light between the oven air
vents.
Possible Cause / Solution
CODE
F-3
F-9
F-19
is no longer displayed.
CAUSE
Touch key error
Main oven heating error
(Upper oven)
Main oven heating error
(Lower oven)