Pioneer DEH-P6200BT Manual De Instrucciones página 17

Operating this unit
1 Press and hold PHONE/
display the connection menu.
# You cannot operate this step during a call.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
Device list (connecting or disconnecting a cellular
phone from the device list)
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to connect/disconnect.
3 Press M.C. to connect/disconnect the selected
cellular phone.
If the connection is established, * is indicated on
the device name.
Delete device (deleting a cellular phone from the de-
vice list)
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to delete.
! Press and hold M.C. to switch the BD address
and device name.
3 Press M.C. to display Delete YES.
4 Press M.C. to delete a cellular phone information
from the device list.
! While this function is in use, do not turn off the
engine.
Add device (connecting a new cellular phone)
/CONNECT to
1 Press M.C. to start searching.
2 Turn M.C. to select a device from the device list.
3 Press and hold M.C. to switch the BD address
4 Press M.C. to connect the selected cellular
SPCL. Device (setting a special device)
Bluetooth devices that are difficult to establish a con-
nection with are called special devices. If your Blue-
tooth device is listed as a special device, select the
appropriate one.
1 Press M.C. to display the setting mode.
2 Use M.C. to select a special device.
3 Turn M.C. to display this unit's device name, BD
4 Use a cellular phone to connect to this unit.
Auto CONN (connecting to a Bluetooth device auto-
matically)
1 Press M.C. to turn automatic connection on or
Visible (setting the visibility of this unit)
! To cancel, press M.C. while searching.
! If the desired device is not displayed, select
Search again.
and device name.
phone.
! To complete the connection, check the device
name (DEH-P6200BT) and enter the link code
on your cellular phone.
! PIN code is set to 0000 as the default. You
can change this code. Refer to PIN code (PIN
code input) on this page.
! If five devices are already paired, Memory full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
Turn to change the menu option. Press to select.
! If five devices are already paired, Memory full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
address and pincode.
! To complete the connection, check the device
name (DEH-P6200BT) and enter the link code
on your cellular phone.
! PIN code is set to 0000 as the default. You
can change this code. Refer to PIN code (PIN
code input) on this page.
off.
Section
02
17
En