Briggs & Stratton ELITE Serie Manual De Uso página 6

I I. If equipped, center t hehandle b racket ongenerator
frame atsupport legendofcradle, asshown.
12.Attach handle b racket withtwoM8x 45mm cap
screws and two locking h exnuts.
13.Check that all f asteners aretight andthetires areinflated
tothevalue markedon thetire o rwithin 15and40 psi.
Install the 8"Wheel Kit as Follows
I. Place bottom of generator cradle on a fiat surface.
2. Placeaxle stud through wheel retainer on cradle frame,
as shown in Figure 2.
3. Use 15/16" wrench to secure the axle stud to frame
with 5/8-18 jam nut.
4. Install the other axle stud in the same manner.
NOTE: Be sure to install wheel with raised hub inboard.
5. Tip unit and installthe wheel. Placefiat washer over
axle stud.
6. Retain wheel on axle stud with retaining pin. Install
other wheel on remaining axle shaft the same way.
7. Attach the vibration mount to the mounting leg with a
capscrew and lock nut.
8. Remove two front nuts from vibration mount on unit
with 13ram wrench. Use these nuts to retain the
mounting leg.
9. Center the lifting handle on generator end of cradle.
Attach handle using two 13mm wrenches with two
capscrews and two hex nuts.
Capscrew
Handle
Grip
Axle Stud
Nut "
Vibration
Nut
Jam Nut
Washer
Existing F asteners
to Secure Leg Retaining P in