Briggs & Stratton ELITE Serie Manual De Uso página 7

ELECTRIC START
Your unit may be equipped with electric start capability but
can be started manually.If you choose not to use the
electric start feature, you do not need to install the battery.
If your unit does not have electric start, ignore this section.
Check Battery / Attach Negative
Battery Wire
The sealed battery on the generator is fully charged and
pre-lnstalled except for the negative (black) battery cable.
To install:
I. Cut off tie wrap securing loose end of negative (black)
cable.
2. Remove nut and washer on negative battery terminal.
3. Slide negative battery cable over screw on negative
terminal (Figure 3).
Negative
battery
cable
Screw \
Positive battery cable
4. Reattach washer and nut and tighten.
5. Verify that connections to battery and generator are
tight and secure.
BEFORE STARTING THE
ENGINE
Add Engine Oil and Fuel
• Place generator on a level surface.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.