Inepro MicroTimer 2400 Manual De Uso página 18

Settings
Function P3, Display indication
Display indication, choice between 00 of --.
Setting "00": display during stand by one point (.), during the prior time, main time and post time two hyphens
will be displayed (--).
Setting "01": display indication in minutes
Function P4, Reduction of the main time
Setting "00": The reduction of the main time during the prior time is impossible
Setting "01": The reduction of the main time during the prior time is possible
Function P5, Pause during the main time
Setting "00": Pause during the main time impossible
Setting "01": Pause during the main time possible
Note, During a pause situation the remaining time will be intermittently indicated (if display indication is activated
(P3)).
Function P6, Main time during the pause
Setting "00": Main time stops during the pause
Setting "01": Main time continues during the pause
Function P7, Main time reduction during the main time
Setting "00": The main time will be finished immediately when the STOP key is pressed.
Setting "01": It is possible to shorten the main time during the main time (by means of the stop key). When the
main time is shortened it will always start with whole minutes.
Note: When activating this function, function P4 has to be connected as well (even if the pre-time is not used).
Setting "02": The Stop key will be blocked during the main time. During the pre-time, it will function as
programmed in function P4.
Function P8, Main time extension during the main time
Setting "00": It is not possible to extend the main time during the main time.
Setting "01": It is possible to extend the main time during the main time.
Note: The maximum amount of start pulses can be programmed in function F4.
Specifications
Supply voltage for the network model:
Voltage range:
Current consumption:
Fuse
Supply voltage for the low voltage model
Voltage range:
Current consumption:
Maximum rupturing capacity of the relay:
Admissible rupturing capacity of the relay:
(ECOS module EM-14)
(ECOS module EM-13)
®
MicroTimer 2400 Version 4.0 05-11-2007
- www.inepro.com
185 VAC - 240 VAC
25 mA maximum
500mA
12 VAC - 24 VAC
12 VDC - 35 VDC
250 mA maximum
6,3 ampere max.
with cosine phi=0,4
6,3 ampere max.
with cosine phi=0,4
-
18