4
Rotate the control dial to select your
listening position, then press it.
Select "FRONT L" if your listening position
is front left, or select "FRONT R" if front
right.
The clock display appears when the setting is
complete.
This setting can then be further configured in
setup or the sound menu.
For details on setting the speaker connection
status, see "Speaker configuration and volume
setup" on page 40. For details on setting the
listening position, see "Optimizing sound for the
listening position — Intelligent Time
Alignment" on page 37.
Note
If you set to "C ON" without connecting the center
speaker, vocal sound is not output, and if you set to
"SUB ON" without connecting the subwoofer, bass
sound is not output.
With the card remote commander
Press M/m instead of rotating the control dial, press
(ENTER) instead of pressing the control dial.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 53.
Detaching the front panel
SOURCE
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OPEN) while the unit is off.
The front panel is flipped down.
2
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
Attaching the front panel
Place the hole A of the front panel onto the
spindle B on the unit, then lightly push the left
side in.
Press (SOURCE) on the main unit (or insert a
disc) to operate the unit.
OPEN
Note
Do not put anything on the inner surface of the front
panel.
1
2
A
B
c
15