Repair - Amprobe CR50A Manual De Uso

1. Remove the screws and lift off the rear case.
2. Fuse Replacement: Remove the blown fuse (5 x 20mm) from
the fuse holder. Replace with a 0.1A/250V quick acting glass
fuse (one spare fuse is located on the right side of the battery
compartment). Amprobe replacement fuse part number is FP
125.
3. Battery replacement: Remove battery and replace with NEDA
type 1604 or equivalent 9-volt alkaline battery.
4. Reassemble the instrument.
Use of an incorrect fuse could result in serious injury
or even death. Failure to turn off the multimeter
before installing the battery could result in damage to
instrument and battery.

Repair

All test tools returned for warranty or non-warranty repair or
for calibration should be accompanied by the following: your
name, company's name, address, telephone number, and proof of
purchase. Additionally, please include a brief description of the
problem or the service requested and include the test leads with
the meter. Non-warranty repair or replacement charges should be
remitted in the form of a check, a money order, credit card with
expiration date, or a purchase order made payable to Amprobe®
Test Tools.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement and check your battery
before requesting repair. During the warranty period any
defective test tool can be returned to your Amprobe® Test Tools
distributor for an exchange for the same or like product. Please
check the "Where to Buy" section on www.amprobe.com for a
list of distributors near you. Additionally, in the United States
and Canada In-Warranty repair and replacement units can also
be sent to a Amprobe® Test Tools Service Center (see address
below).
� Warning
7