auna Kentucky 10033772 Manual De Instrucciones página 22

EN
22
receptacles and the point where they exit from the product.
• Protective attachment plug - The product is equipped with an
attachment plug having overload protection. This is a safety feature.
See Instruction
• Manual for replacement or resetting or protective device. If
replacement of the plug is required, be sure the service technician has
used a replacement plug specified by the manufacturer that has the
same overload protection as the original plug
• Outdoor Antenna Grounding - If an outside antenna or cable system
is connected lo the product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and
built-up static charges.
• Lightning - For added protection for this product during a lightning
storm or when it is left unattended and unused for long period of time,
unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the product due to lightning and
power-line surges.
• Power lines - An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from
touching such power lines or circuits, as contact with them might be
fatal.
• Overloading -Do not overload wall outlets, extension cords, or integral
convenience receptacles as this can result in a risk of fire or electric
shock.
• Object and liquid entry - Never push objects of any kind into this
product through openings as they may touch dangerous voltage points
or short-out parts that could result in a fire or electric shock. Never spill
liquid of any kind on the product.
• Servicing - Do not attempt to service this product yourself as opening
or removing covers may expose you to dangerous voltage or other
hazards.
• Refer all servicing lo qualified service personnel.
• Damage requiring service - Unplug this product from the wall outlet
and refer servicing to qualified service personnel under the following
conditions:
a. When the power supply cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the product,
c. If the product has been exposed to rain or water,
d. If the product is not operating normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions as an improper adjustment of other controls
may result in damage and will often require extensive work by a