6.
Operation
Refer to the illustrations on page 2 of this manual.
1.
Make sure both the receiver and transmitter are powered.
2.
The receiver will ring when the button on the transmitter [2] is
pressed.
3.
Select the melody with the melody selector [5] and adjust the
volume with volume control button [4].
7.
Pairing
1.
On the receiver, hold the button pressed for 5 seconds until you
hear a "ding-dong" sound.
2.
Now, press the transmitter button. The transmitter emits a
"ding" sound to confirm successful pairing. The receiver emits a
"ding-dong" sound when it exits the pairing mode.
8.
Technical Specifications
wireless ................................................................ yes
operating range .............................. 150 m in open area
self-learning .......................................................... yes
bell push.......................................................... kinetic
number of sounds ................................................... 32
IP rating (transmitter) .......................................... IP44
power supply receiver
EDKP1 ........................................ standard Euro plug
EDKM1 ................................. 3 x 1.5 V AA (not incl.)
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.perel.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
V. 04 – 17/07/2019
EDKP1/EDKM1
9
©Velleman nv