Assembling; Using The Pasta Maker; Preparing The Ingredients - Philips HR2375 Manual Del Usuario

Assembling

1 Push the mixing chamber into the appliance. (Fig. 7)
2 Point the mixing paddle to the hole in the main unit. Insert the mixing paddle all the
way into the main unit.
3 Attach the disc holder onto the appliance.
4 Put the shaping disc onto the disc holder , and make sure it is firmly fixed on the disc
holder. (Fig. 10)
Note: Make sure the inner cavity of the shaping disc and disc holder is properly fitted.
(Fig. 11)
5 Attach the front panel to the main unit.
Note:
y Make sure the front panel is completely fastened before using the appliance.
y The front panel is heavy. Take extra caution when assembling it.
6 Fasten the front panel control knobs.
Note: If the front panel or the shaping disc is not properly assembled, a safety switch
will prevent the appliance from working.
7 Close the mixing chamber lid.
Note: If the mixing chamber lid is not properly installed, the safety switch will prevent
the appliance from working.

Using the Pasta maker

Preparing the ingredients

Note: Use the supplied flour/water cup to measure flour and liquid.
Flour
1 cup of flour (~250 g)
2 cups of flour (~500 g)
1 Use a kitchen scale to measure the flour. (Fig. 15)
Note: Refer to the table above or the recipe book for the correct ratios.
2 Remove the mixing chamber lid. (Fig. 3)
3 Pour the flour into the chamber. (Fig. 16)
Note: Do not put less than 200g or more than 500g of flour in the chamber.
4 Measure the required amount of liquid according to the flour you have used. (Fig. 17)
Note: Refer to the table above or the recipe book for the correct ratios.
(Fig. 8)
(Fig. 9)
(Fig. 12)
(Fig. 13)
(Fig. 14)
Water
ENGLISH
7
Water + Egg