Epson TM-L90 Manual Del Usuario página 10

English
5. Make sure that the mode switch is set to the mode you are going to use.
(To the right for the label peeler issuing mode, or to the left for the label
continuous issuing mode.)
6. Pull out the paper until the end exactly reaches the guideline (indicated with
arrows) shown in the illustration below. Eliminate any slack in the roll paper,
and then close the roll paper cover.
Note:
Making sure the paper end is at the guideline reduces the number of labels required
for detecting the minimum paper length. The number of labels issued depends on the
length of the label, but 2 labels are issued when the length of the label is less than
50 mm {2"}, and 1 label is issued when it is 50 mm {2"} or more.
7. After the paper is automatically fed and the first label comes out, the
PAPER OUT LED starts flashing.
6 TM-L90 with Peeler User's Manual
Left: label continuous
issuing mode
Right: label peeler
issuing mode