Restriction of Use
When this product is used for applications requiring high reliability/safety, such
as transportation devices related to aviation, rail, marine, automotive, etc.;
disaster prevention devices; various safety devices, etc.; or functional/precision
devices, etc.; you should use this product only after giving consideration to
including fail-safes and redundancies into your design to maintain safety and
total system reliability. Because this product was not intended for use in
applications requiring extremely high reliability/safety, such as aerospace
equipment, main communication equipment, nuclear power control equipment,
or medical equipment related to direct medical care, etc., please make your own
judgment on this product's suitability after a full evaluation.
Control Panel
LEDs and Button
POWER LED
Is on when the power is on, and is off when the power is off.
ERROR LED
Is on when the printer is offline, and is off when the printer is online. It flashes
when an error occurs.
PAPER OUT LED
Comes on when roll paper is used up or not installed. When roll paper is being
installed, it starts flashing when the first label comes out after the roll paper cover
is closed, and goes off when the
is issuing labels, it starts flashing when a label is issued and goes off when the
issued label is removed from the peeler. It also flashes when the printer is in a wait
status for the
FEED button
Feeds the roll paper.
Power Switch and Power Switch Cover
The power switch is on the top left of the printer. Press it to turn on the printer,
and press and hold it for more than 3 seconds to turn off the printer.
Power Switch Cover
You can use the enclosed power switch cover to make sure that the power switch
is not accidentally pressed. Peel off the backing tape and press the cover into place
to install it.
FEED
button to be pressed.
PAPER FEED
button is pressed. When the printer
TM-L90 with Peeler User's Manual 3
English