Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Using the System
So ce
selectioH
You can switch between sources by pressing the appropriate source button on the
remote control. Before you begin, program the remote to control your source
(see page 22).
Select
a source
connected
to the system
If your source is connected to the console and does not use CEC, follow this
procedure to set the console to the appropriate mode and turn on the source.
1.
Power on the system.
2.
Press the button for the source you want to control.
The source button glows.
3.
Press
The source powers on.
Select
a source
connected
to your
TV
If your source is connected to your TV, follow this procedure to select the
appropriate TV input.
1.
Power on the system, your8,'
and the appropriate
source.
2.
Press _
to select the correct input on your TV.
You may need to press _
several times to select the TV input for
the source.
On some TVs, _
displays a menu. Use the remote control to choose the
correct TV input and close this menu.
UniveFsal
souFce
buttons
and
console
connectors
The source buttons on your remote control correspond
with the connectors
on the
back of the console. For example,
corresponds
with the BD-DVD HDMI
connector.
Your source buttons work with any source that is connected to the corresponding
connector. If you have a secondary DVD or Blu-ray Disc
TM
player and connect it to
the CBL-SAT connector, it can be programmed
to work with
If you are using the optical, coaxial, or analog connectors,
you must set the input
for the appropriate
source. You can access these settings using the System menu
(see page 25).
English - 23
Publicidad
Capítulos
Tabla de contenido
